Flite Controller

  • Updated

Post Ride

1. Rinse the Flite Controller in fresh water to clean away salt and debris. Ensure a steady stream of fresh water is applied directly into the trigger housing. While doing so press and de-press the trigger numerous times to loosen any sand, grit, debris that may affect its performance.

2. Peel out the rubber cover on the underside and clean this with fresh water. Ensure this area is dry before replacing the cover.

Regular maintenance
Pre and post season, the 3 torque screws on the underside of the controller can be undone to release the trigger. This will allow you thoroughly clean and inspect both the trigger, spring and magnet.

 

Storage
Store in a cool dry place, out of the sun.

 

Was this article helpful?

3 out of 7 found this helpful

Comments

0 comments

Article is closed for comments.