MN Carbon eFoil Maitenance

Post ride

1. Disconnect the Flitecell power cables and remove Flitecell.

2. Rinse thoroughly with clean fresh water after every use. Dry thoroughly.

3. Rinse the inside of the mast (through the notch in the bottom of the fuselage) with fresh water.

4. Rinse around the mast flange to wash salt away from the board connection area (if keeping the board and foil attached).

5. Do not spray water directly into the flitecell compartment. Wipe internally with an already damp microfibre towel or similar.

Regular maintenance
1. Disassemble the eFoil from the board.

2. Remove the wing, fuselage cover and stabiliser from the tail, and clean thoroughly with fresh soapy water to remove any built-up salt or sand.

3. Periodically clean with a low level ph wash/soapy water and a clean microfibre towel.

4. Periodically you may give the carbon a shine with some carbon polish or silicone spray. 

5. Check electrical connections and spray contact cleaner to clean connections periodically.

6. Give the Flitebox (plastic components) a wipe down with silicone spay (do not spray near power cables) Never put direct water onto the Flitebox.

Storage
1. Always store the eFoil in a clean, dry environment out of direct sunlight. Ensure it does not go into the bag wet.