Race Board Handle Installation

1. On the deck of the Race board, you will find 4 pre drilled pilot holes where the handle screws are to be positioned.
2. Tighten the 4 x handle screws into the predrilled screw holes in the nylon block of the board using a Phillips head screwdriver. Force is needed and ensure you do not burr the screw heads.
3. Tighten the screws until the heads of the screw sit 8mm off the deck of the board.
4. 
5. Once installed place the handles over the screws. Push down to ensure a snug fit and then rotate the screws 90 degrees using the designated handle tool to lock the handles into place. Repeat this step for remaining fasteners.

.